Pretty Spool: Pattern Shapes

Pretty Spool has very few pattern parts. But there is one tricky maneuver you’ll have to master as we create the design. I don’t want to scare you but think of it as walking and chewing gum at the same time.

It’s called “bias fusing” and we’ll use it to make the spool and that wavey thread coming out of the needle. But first, we need the parts.

Please note: Directions are first given here on the blog, then added to the Pretty Spool Tutorial page as we go.

Step #4

  • Print out the Pretty Spool pattern by downloading the Pretty Spool pattern as a Word Document. Or click here to download and print out the Pretty Spool pattern as a PDF.
  • Place the silicone release paper (the paper you’ve just removed from the fabric) or parchment paper on the needle pattern.
  • Trace the pattern with the black Sharpie marker or a lead pencil. (Please note that any writing or numbers written on the release paper will also transfer to the fabric.)
  • Place the marker or ink side of the release paper onto the glue or fused side of the needle fabric.
  • Iron the paper in place for about 4 – 5 seconds with a hot dry iron.
  • After the fabric cools, remove the release paper from the fabric.
  • The ink from the tracing will transfer to the glue. It’s a miracle!
  • Cut out the needle shape just inside the black line with scissors.
  • Repeat the steps above to make the other Pretty Spool pattern parts.

Step #5

  • Cut the thread fabric on the bias (from corner to corner) to form 2 triangles.
  • Cut 7 strips measuring a scant 1/4″ wide from the long bias sides of each triangle for a total of 14 bias thread strips.
  • Place the spool inside the book of parchment paper. Close the book and fuse-tack into place. Fuse tacking is holding the hot iron in place on the fabric for about 3 seconds.
  • Starting at the bottom of the spool body, fuse-tack a thread strip across the spool from side to side. Follow the curve of the bottom edge of the spool as you fuse. Make sure your iron is clean as you will be ironing directly on the fabric.
  • Repeat the steps above adding more thread strips to cover the spool body. Space the thread strips about 1/16″ to 1/8″ apart
  • After the fabric cools, remove the spool from the parchment paper.  Trim the edges to remove the thread strip ends.

Step #6

  • Center the background fabric vertically inside the book. Close the book and fuse-tack into place.
  • Center the spool about 3″ up from the bottom edge of the background fabric. Close the book and fuse-tack into place.
  • Space the remaining spool parts in order about 1/16″ apart above and below the spool. Use the pattern printout or photo as a guide. Close the book and fuse-tack into place.
  • Position the needle parts on top of the spool at an angle. Close the book and fuse-tack into place.